Author
Gemici, Z., Budaklı, Mete
Publication Date
2023-04
Publication Place
-
Taylor & Francis
Subject
Forced convection, Miniature-pin fin, Rectangular narrow channel, Single-phase flow, Tip clearance
Type
Periodical
Language
English
Digital
Yes
Manuscript
No
Library
Özyeğin University
Library Asset ID
1040-7782
Record ID
e1594f8e-6ecf-4129-80e4-d962120de65c
Date
2023-04
Sample Text
This study presents the numerical analysis of single-phase forced convection heat transfer and pressure drop during internal flow in a shallow, rectangular sandwich-like copper channel heated from both the top and the bottom. Simulations were conducted using a commercial finite volume solver that solves governing continuity, momentum, and energy equations simultaneously. The bottom side of the channel was considered with arrays of rectangular miniature-pin fins. The miniature-pin fin geometry was modeled in a staggered configuration with tip clearance from the opposite surface while the orientation of the fins was directed parallel to the flow direction of the working fluid. Water was used as a working fluid with a fully developed velocity profile at the channel entry. Simulations were carried out for varying inlet temperatures and mass flow rates. All calculations were performed with the RNG k-ε model to model complex turbulent flows appropriately. Grid independence and validation analyses were also conducted. With the validated model, additional analyses were performed for 0, 0.1, 0.3, 0.6, and 1 mm tip clearances, and correlations were proposed after performing regression analyses for the friction factor and heat transfer coefficient. The calculations revealed that in contrast to a straight (nonfinned) surface, up to 220% larger heat transfer coefficients could be obtained for the finned surfaces under comparable operating conditions. It was also shown that tip clearance in turbulent flow affects heat transfer negatively. With increasing clearance, the Nusselt number decreased; in other words, heat transfer worsened. On the other hand, the use of miniature-pin fins led to a rise in the pressure drop over the entire heated length. For the Reynolds number spectrum of 4000–20000, the ratio of the friction coefficient of the finned surface to the friction coefficient of the nonfinned surface varied from 6 to 5 while with a further reduction in pressure loss a value of approximately 4 could be obtained for larger tip clearances. Hence, with larger tip clearances, the friction factor decreased, reflecting the abatement of pressure loss.
DOI
10.1080/10407782.2023.2202883
